[Gllug] route command in rc.local

[Stephen Harker]

----- Original Message -----
> try /sbin/route   it may have not set up the correct paths, also , i would
not
> put it in rc.local cos if memory serves, the network isnt up then,
therefore
> there will be no eth0, try putting it just after the end of the network
bit in
> rc.sysinit (i think)

Umm, no. rc.local is run at the end of everything else usually, so the
network is well and truly up by then. If you are on RH, can't you just use
that poxy linuxconf thing and add the route information there?

Steve



-- 
Gllug mailing list  -  Gllug at linux.co.uk
http://list.ftech.net/mailman/listinfo/gllug