[Gllug] Understanding ntop

[Wiehe, Simon]

> I seem to remember just using the graphs on eth1 (connected to the adsl  
> router) to show peak usage.  It could be that this will also show you  
> total usage, but I wasn't concerned with that.

The bit I am interested in is just the ADSL router :-) and the total usage
rather than the peak :-) so just about the opposite to what you needed ;-)

I will continue to have a look around

Thanks

Simon


==============================================================================
This message is for the sole use of the intended recipient. If you received
this message in error please delete it and notify us. If this message was
misdirected, CSFB does not waive any confidentiality or privilege. CSFB
retains and monitors electronic communications sent through its network.
Instructions transmitted over this system are not binding on CSFB until they
are confirmed by us. Message transmission is not guaranteed to be secure.
==============================================================================

-- 
Gllug mailing list  -  Gllug at gllug.org.uk
http://lists.gllug.org.uk/mailman/listinfo/gllug