[Gllug] ifconfig - eth2 not "RUNNING"

[Jon Nangle]

On Mon, Nov 27, 2006 at 03:03:03PM +0000, Garry Heaton wrote:

> [root at robinson ~]# ifconfig
> eth0      Link encap:Ethernet  HWaddr 00:14:6C:8B:75:97
>           inet addr:10.0.0.15  Bcast:10.0.0.255  Mask:255.255.255.0
>           inet6 addr: fe80::214:6cff:fe8b:7597/64 Scope:Link
>           UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
>           RX packets:2173 errors:0 dropped:0 overruns:0 frame:0
>           TX packets:2279 errors:0 dropped:0 overruns:0 carrier:0
>           collisions:0 txqueuelen:1000
>           RX bytes:1550661 (1.4 MiB)  TX bytes:343890 (335.8 KiB)
>           Interrupt:225 Base address:0xa800
> 
> eth2      Link encap:Ethernet  HWaddr 00:E0:81:5E:C1:41
>           inet addr:192.168.1.254  Bcast:192.168.1.255  Mask:255.255.255.0
>           inet6 addr: fe80::2e0:81ff:fe5e:c141/64 Scope:Link
>           UP BROADCAST MULTICAST  MTU:1500  Metric:1
>           RX packets:0 errors:0 dropped:0 overruns:0 frame:0
>           TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
>           collisions:0 txqueuelen:1000
>           RX bytes:0 (0.0 b)  TX bytes:0 (0.0 b)
>           Interrupt:209

Silly question but do you have a link light on the card/switch? It
doesn't look like the driver is passing any packets up the stack.

Jon
-------------- next part --------------
-- 
Gllug mailing list  -  Gllug at gllug.org.uk
http://lists.gllug.org.uk/mailman/listinfo/gllug