[Gllug] CentOS 4.2 install hangs right at the end

[Garry Heaton]

Same. After the freeze nothing is available.

Garry

william pink wrote:
> What about VC1 and 2 :o) ?
> 
> On Mon, May 19, 2008 at 4:25 PM, Garry Heaton <garry at heaton6.freeserve.co.uk>
> wrote:
> 
>> Karanbir Singh wrote:
>>> Garry Heaton wrote:
>>>>>> I have the RAID5 array configured and the proprietary raid card driver
>>>>>> loaded successfully at startup.  The install completes up to the very
>> last
>>>>>> "Post-install configuration" then everything hangs. Same through 3
>> attempts.
>>>>> see anything interesting on VC#3 VC#4 or VC#5 ?
>>>>>
>>>>> Also, why are you using such an old version of CentOS ?
>>>>>
>>>> How do I access VC#3, 4 etc? This was the last version of RHEL supported
>> by
>>>> Broadcom for this raid card.
>>> ALT+CTRL+F3 from the GUI install screen should take you to VC3, then
>>> ALT+F4 / ALT+f5
>>>
>>>
>>>
>> When I access these virtual terminals the output stops so they're no use in
>> diagnosing the freeze during the Post-Install phase since I have no access
>> to VC3-7 following the freeze.
>>
>> Garry
>>
>>
>> --
>> Gllug mailing list  -  Gllug at gllug.org.uk
>> http://lists.gllug.org.uk/mailman/listinfo/gllug
>>
> 

-- 
*****************************************************
www.usableit.co.uk
Web Development, Networking & System Administration
*****************************************************





-- 
Gllug mailing list  -  Gllug at gllug.org.uk
http://lists.gllug.org.uk/mailman/listinfo/gllug