[Gllug] PCI ADSL2+ Cards

[Andy Millar]

On Mon, 2011-01-17 at 00:11 +0000, Andy McGarty wrote:
> On 16/01/2011 23:00, Andy Millar wrote:
> > Gllugers,
> >
> > I've recently obtained a http://linitx.com/viewproduct.php?prodid=12181
> > and am trying to get it working with a BeThere DSL connection.
> >
> > However I can't find any documentation on the card or any advice on how
> > to configure it up with BeThere and get it working.
> >
> > Does anyone here have any experience with these (or similar) cards?
> >
> > Andy
> >
> When I looked at these (before chickening out and going for a stand 
> alone router) I found a configuration page that spoke about putting it 
> into a config mode to put in the settings before restarting it as a 
> bridge device.
> 
> I don't know if its the same as you have, but here is a link.
> http://traverse.kd85.com/

I've tried that, but with no luck.

Sadly the card is slightly different (see:
http://www2.multithread.co.uk/mtcshop/images/linitx.com/products/ADSL2__PCI_Card_main.jpg ) with a different ADSL controller (Infineon vs Connexant?).

Configuring up eth1 with 192.168.1.2 and pinging/telnetting/other
192.168.1.1 doesn't work, and tcpdumping whilst doing this confirms the
lack of joy.

Andy

-- 
Gllug mailing list  -  Gllug at gllug.org.uk
http://lists.gllug.org.uk/mailman/listinfo/gllug