[Scottish] SuSe 10 Installation

[Robert Barbour]

 Billy wrote:
 If you log in as root you should be able to run "sax2" to set up the
 graphics.  It's probably just setting the refresh rate to high for your
 monitor.
  
OK, I tried that ... and failed!

I logged in as root, then typed SAX2 and got the blank screen, managed to read the brief message this time ...

"H = 67 kHz, V = 83 Hz, Input signal out of range."

I also tried "Yast2" from the root prompt, with the same blank screen result.

Once the screen goes blank, switching the monitor off, then on again, gets the message on the screen (briefly).

What to try next?

Regards

Rob