[SWLUG] Ancient sb card under Red Hat 9

[Gareth Watkins]

  I can't get sound working under Red Hat 9 on my daughter's (oldish) PC.
The RH9 install seemed to go smoothly. 
On the first boot after install, RH found the card & offered to configure it, 
so I clicked the "Configure" button. But see logfile extract below.
Unfortunately, no sound comes out when I play an audio CD. If I tick Sound 
For Events in the Gnome Control Centre, I thereafter get a very faint burp 
occasionally e.g. when closing a window. So something is happening somewhere.

(In the old days, I used to use /sbin/pnpdump, then uncomment some lines in 
/etc/isapnp.conf, and this got things working. But these things don't seem 
to exist anymore.)

Can anyone tell me whether there's a simple way of sorting this out? Or 
should I just go an buy a cheap PCI card?
Thanks,
Gareth


===========================
Sep 1 18:35:34 localhost kernel: sb: Creative ViBRA16X PnP detected
Sep 1 18:35:34 localhost kernel: sb: ISAPnP reports 'Creative ViBRA16X PnP' at i/o Ox220, irq 10, dma 1, 3
Sep 1 18:35:34 localhost kernel: SB 4.16 detected OK (220)
Sep 1 18:35:34 localhost kernel: sb: Interrupt test on IRQ10 failed - Probable IRQ conflict
Sep  1 18:35:34 localhost kernel: SB 16: Bad or missing 16 bit DMA channel
Sep  1 18:35:34 localhost kernel: sb: 1 Soundblaster PnP card(s) found.
Sep  1 18:35:34 localhost modprobe: modprobe: Can't locate module sound-service-0-3
Sep  1 18:36:44 localhost kernel: Sound: DMA (output) timed out - IRQ/DRQ config error?
Sep  1 18:36:48 localhost last message repeated 3 times