[Gllug] Can's see Linux RAID partitions after board swap

[Garry Heaton]

I built an office server using Centos 4.1 with a 2-disk Linux software RAID
0 array which was fine until I noticed a problem with the mother board.
Swapped the motherboard hoping I could use the Centos disk in rescue mode or
Knoppix to reload Grub but neither detects the original /dev/md0. All that
can be seen is the /boot partition. Any ideas?

Garry
-- 
Gllug mailing list  -  Gllug at gllug.org.uk
http://lists.gllug.org.uk/mailman/listinfo/gllug